Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

Trans-Cal Altimeter Encoder 30K SSD120-30N-RS232 Mod 1

https://www.roctexo.com/web/image/product.template/9135/image_1920?unique=7d80ac8
Part numbers : RX1-11-09917 , SSD120-30N-232-M1 , 11-09917
Unit of Measure: EA

442.65 EUR / EA 442.65 EUR 442.65 € excl. VAT

442.65 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
1 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The Trans-Cal SSD120-30N-232-M1 is a solid-state altitude encoder/digitizer in an RS-232 configuration. This 30K model is specified for an operating altitude range of -1,000 to +30,000 ft.

The Mod 1 configuration is designed for use with early Narco AT-5A, AT-6A, AT-50 and AT-50A transponder installations. Trans-Cal states that this modification removes output decoupling capacitors and should be selected where the applicable transponder installation requires it.

  • Manufacturer part number: SSD120-30N-232-M1
  • Solid-state altitude encoder/digitizer
  • RS-232 configuration
  • Operating altitude range: -1,000 to +30,000 ft
  • Standard operating temperature range: -20 °C to +70 °C
  • Mod 1 configuration for applicable early Narco transponder installations
  • Unit of measure: each

Please verify the required encoder configuration, interface protocol, wiring, installation requirements and aircraft approval basis against the applicable Trans-Cal installation documentation before purchase or installation.

Relevant manufacturer documentation is available from Trans-Cal legacy manuals and Trans-Cal technical FAQs.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.