Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

TCW Safety Trim Single Axis Servo Controller

https://www.roctexo.com/web/image/product.template/13777/image_1920?unique=8ef9bbe
Part numbers : RX1-11-08506 , ST-1-12V , 11-08506
Unit of Measure: EA

215.15 EUR / EA 215.15 EUR 215.15 € excl. VAT

215.15 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The TCW Technologies Safety-Trim ST-1-12V is a single-axis electronic speed controller for electric trim servos in experimental aircraft. It combines directional switching and adjustable servo-speed control in one compact controller.

Time-limited trim operation is designed to reduce the possibility of runaway trim. A reverse function supports recovery towards a neutral trim condition in the event of an inoperative trim switch. The controller is short-circuit protected and protected against reverse polarity.

  • Manufacturer part number: ST-1-12V
  • Single-axis controller for 12 V DC trim motors rated up to 1 A
  • Input voltage: 10–30 V DC
  • Adjustable output voltage: 6–12 V DC, maximum 1 A
  • Factory-set trim-operation limit: 3 seconds per continuous switch actuation
  • 15-pin D-sub controller connector
  • Approximate enclosure dimensions: 145 × 64 × 38 mm
  • Approximate weight: 170 g

The ST-1-12V is intended for experimental-category aircraft only and is not EASA/FAA approved. Installation and wiring must be evaluated for the specific aircraft and trim-servo installation.

Manufacturer documentation: Safety-Trim ST-1-12V installation instructions.

Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.