Skip to Content
  1. All Products
  2. All Products
  3. Tailwheel Leaf Spring #2 1-1/2
Select currency EUR
Tailwheel Leaf Spring #2 1-1/2

Image for illustration only. It may show a product series rather than the exact product offered.

Tailwheel Leaf Spring #2 1-1/2

https://www.roctexo.com/web/image/product.template/42853/image_1920?unique=8ef9bbe
Part numbers : RX1-06-14300 , UB-562SET , 06-14300
Unit of Measure: EA

258.04 EUR / EA 258.04 EUR 258.04 € excl. VAT

258.04 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
2 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

Tailwheel Leaf Spring #2 is a steel tailwheel leaf-spring component supplied under manufacturer part number UB-562SET. It corresponds to a Set No. 2, three-spring arrangement for tailwheel landing-gear installations.

  • Manufacturer part number: UB-562SET
  • Roctexo part number: RX1-06-14300
  • Spring width: 38 mm
  • Fuselage-end hole diameter: 9.5 mm
  • Tailwheel-end hole diameter: 9.5 mm
  • Bolt-centre spacing: approximately 286 mm
  • Number of springs in set configuration: 3

The available source identifies T-Craft BC-12D as the original application and states that the item is individual for PA-17 use, but is not approved for PA-15 use. FAA/PMA-approved subcomponents are stated by the source; no EASA approval status is stated. Confirm part-number applicability, installation arrangement and regulatory approval against the aircraft’s approved maintenance data before installation.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.