Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

Clamp MS21919-WdG4

https://www.roctexo.com/web/image/product.template/45053/image_1920?unique=703fd73
Part numbers : RX1-MS21919-WDG4 , MS21919WDG4 , MS21919-WDG4
Unit of Measure: EA

0.59 EUR / EA 0.59 EUR 0.59 € excl. VAT

0.59 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
35 EA ready to ship Tomorrow
Order before 15:30 CET Tomorrow
10,207 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The MS21919WDG4 is a loop-type cushioned aluminium-alloy clamp for securing lines or tubing with a nominal diameter of 6.4 mm.

The bonded inner and edge cushion is non-fuel-resistant. Its WDG wedge-cushion design is intended to provide a close fit and help reduce vibration and line abrasion.

  • Manufacturer part number: MS21919WDG4
  • Clamp series: MS21919 WDG
  • Nominal tube diameter: 6.4 mm
  • Construction: aluminium-alloy loop clamp with bonded cushion
  • Cushion type: WDG wedge type, non-fuel-resistant
  • Unit of measure: each

Please verify the required part number, clamp size and material suitability against the applicable maintenance data before installation.

Tube Dia.Dash No.
DG
Dash No.
WDG
1/4MS21919-WDG4WDG4

Overview

Loop-type cushioned aluminum alloy clamp. Cushion (non-fuel resistant) is bonded to inner surface and edges of clamp. WDG clamps are cushion wedge type. Cushion assures tight fit and eliminates vibration, thus preventing line abrasion.

Note: Revision E only applies to WDG clamps. See Tech Data Sheet.



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.