Skip to Content
  1. All Products
  2. All Products
  3. Clamp MS21919-WdG13
Select currency EUR

Image for illustration only. It may show a product series rather than the exact product offered.

Clamp MS21919-WdG13

https://www.roctexo.com/web/image/product.template/86771/image_1920?unique=b30b3d2
Part numbers : RX1-MS21919-WDG13 , MS21919WDG13 , MS21919-WDG13
Unit of Measure: EA

1.13 EUR / EA 1.13 EUR 1.13 € excl. VAT

1.13 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
20 EA ready to ship Tomorrow
Order before 15:30 CET Tomorrow
Up to 1,478 EA ready to ship on Monday 2026-09-28
Order before 15:30 CET Tomorrow
Up to 2,296 EA ready to ship on Thursday 2026-10-01
Order before 15:30 CET Tomorrow
3,221 EA available on request, fees apply
Special order from vendor stock.

The MS21919WDG13 is a loop-type cushioned aluminium-alloy clamp from the MS21919 WDG series. It is intended for securing a nominal 13/16 in (approximately 21 mm) tube or line diameter.

The WDG configuration uses a wedge-type cushion bonded to the clamp’s inner surface and edges. This non-fuel-resistant cushion is designed to provide a close fit, reduce vibration and help minimise line abrasion.

  • Manufacturer part number: MS21919WDG13
  • Roctexo part number: RX1-MS21919-WDG13
  • Clamp type: loop-type cushioned clamp
  • Series/configuration: MS21919 WDG, wedge-type cushion
  • Nominal tube diameter: 13/16 in (approximately 21 mm)
  • Material: aluminium alloy clamp body
  • Cushion: bonded, non-fuel-resistant
  • Approximate item weight: 9 g
  • Unit of measure: each

Please verify the part number, clamp size and cushion suitability against the applicable maintenance data before installation.

Contact Us

Terms and Conditions

Share

Tube Dia.Dash No.
DG		Dash No.
WDG
13/16MS21919-WDG13WDG13

Overview

Loop-type cushioned aluminum alloy clamp. Cushion (non-fuel resistant) is bonded to inner surface and edges of clamp. WDG clamps are cushion wedge type. Cushion assures tight fit and eliminates vibration, thus preventing line abrasion.

Note: Revision E only applies to WDG clamps. See Tech Data Sheet.



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.