Skip to Content
  1. All Products
  2. All Products
  3. Bolt Drilled AN6-15
Select currency EUR
Bolt Drilled AN6-15

Image for illustration only. It may show a product series rather than the exact product offered.

Bolt Drilled AN6-15

https://www.roctexo.com/web/image/product.template/127856/image_1920?unique=62e95b9
Part numbers : RX1-AN6-15 , 5306-00-151-1336 , 11689-1 , AN6-15 , AN6-15
Unit of Measure: EA

3.41 EUR / EA 3.41 EUR 3.41 € excl. VAT

3.41 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
1 EA ready to ship Today
Order before 15:30 CET Today
31 EA available on request, fees apply
Special order from vendor stock.

The Airfasco AN6-15 is a drilled hex-head aircraft bolt for hardware installations requiring an AN6-size fastener. The drilled shank is intended for cotter-pin retention arrangements where the applicable assembly design specifies this type of bolt.

  • Manufacturer part numbers: AN6-15; 11689-1
  • Thread: 3/8-24
  • Nominal length: approximately 44 mm, measured from under the head to the end of the shank
  • Grip length: approximately 27 mm
  • Drilled shank configuration
  • Alloy-steel bolt with cadmium plating

Confirm the required fastener callout, grip length, thread engagement, material condition, and installation requirements against the applicable approved maintenance data before use.

Contact Us

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.