Bolt Undrilled AN4-10A
Part numbers
:
RX1-AN4-10A
, 05336-10
, AN4-10A
Unit of Measure:
EA
| Dash No. | Nominal Length | Grip Length |
|---|---|---|
| -10 | 1-1/32 | 9/16 |
Overview
| Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground and threaded after heat treatment. Minimum tensile strength 125,000 PSI. Cadmium plated per specification QQ-P-416A, Type II, Class 3. Available with shank drilled for cotter pin or undrilled for stop nut application, and with or without drilled head for safety wire. Specify bolts to have undrilled shank by adding letter "A" after the dash number. For bolts with drilled head add letter "H" after the AN number. See illustrated examples. "C" represents Type 431 Stainless Steel (contains iron which is magnetic). The length of AN aircraft bolts is measured from under the head to the end of the shank. The "grip" is the unthreaded portion of the shank. See table for conversion of length and/or grip to proper AN callout. |
Reference Chart
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.
These products might also be of interest
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.