Skip to Content
  1. All Products
  2. All Products
  3. Taper Pin AN386-1-9
Select currency EUR
Taper Pin AN386-1-9

Image for illustration only. It may show a product series rather than the exact product offered.

Taper Pin AN386-1-9

https://www.roctexo.com/web/image/product.template/55515/image_1920?unique=bdb3d68
Part numbers : RX1-AN386-1-9 , 10512-1 , AN386-1-9
Unit of Measure: EA

9.03 EUR / EA 9.03 EUR 9.03 € excl. VAT

9.03 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 1 EA ready to ship on Thursday 2026-10-01
Order before 16:00 CET on Tuesday 2026-09-29
15 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The AN386-1-9 is an alloy-steel taper pin identified by manufacturer part number 10512-1. It is cadmium plated and manufactured with a taper of 0.500 in/ft.

The AN386 designation uses the first dash number to identify the Brown & Sharpe taper-pin reamer number and the second dash number to identify grip length in eighths of an inch. For AN386-1-9, the grip-length designation is 9/8 in (approximately 28.6 mm).

  • Part number: AN386-1-9
  • Manufacturer part number: 10512-1
  • Material: alloy steel
  • Minimum tensile strength: 125,000 psi
  • Finish: cadmium plated
  • Taper: 0.500 in/ft
  • Unit of measure: each

Source guidance identifies AN975 taper-pin washers, AN320 shear castle nuts and cotter pins, or AN364 elastic stop nuts as associated installation hardware. Installation and selection should be performed in accordance with the applicable approved maintenance data and by appropriately qualified personnel.

Contact Us

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.