Skip to Content
  1. All Products
  2. All Products
  3. Camloc Fastener 26S8-7
Select currency EUR
Camloc Fastener 26S8-7

Image for illustration only. It may show a product series rather than the exact product offered.

Camloc Fastener 26S8-7

https://www.roctexo.com/web/image/product.template/10310/image_1920?unique=182fd28
Part numbers : RX1-26S8-7 , 26S8-7 , 26S8-7
Unit of Measure: EA

6.11 EUR / EA 6.11 EUR 6.11 € excl. VAT

6.11 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
5 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The Camloc® 26S8-7 is a 2600-series quarter-turn stud assembly designed for quick-release panel fastening arrangements. It features a cadmium-plated steel construction and a Phillips cross recess.

Part number 26S8-7 identifies the protruding-head, -7 length configuration. In Camloc 2600-series selection guidance, the -7 stud corresponds to a total grip-thickness range of approximately 5.3 to 6.1 mm when used with the referenced 212-12 receptacle configuration.

  • Manufacturer part number: 26S8-7
  • Roctexo part number: RX1-26S8-7
  • Series: Camloc 2600
  • Fastener type: quarter-turn stud assembly
  • Head drive: Phillips cross recess
  • Material/finish: cadmium-plated steel
  • Unit of measure: each (EA)

Please verify the required stud length, mating receptacle, retaining arrangement and installation requirements against the applicable maintenance data before ordering or installation.

Manufacturer documentation: Camloc 2600/2700 Series quick-release fasteners.

Contact Us
Orders with purchased items below 100.00 € incur a small order fee of 10.00 €. Both amounts exclude VAT. Shipping, other fees and core deposits do not count towards the limit.

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.