Skip to Content

CaN24TsT120 Canbus Wire 120 Ohm

https://www.roctexo.com/web/image/product.template/126666/image_1920?unique=bd6e5c2
Part numbers : RX1-11-17264 , CAN24TST120 , 11-17264
Unit of Measure: FT

5.29 EUR / FT 5.29 EUR 5.29 € excl. VAT

5.29 EUR / FT excl. VAT

Not Available For Sale

This combination does not exist.

Availability
41 FT ready to ship on Monday 2026-08-10
Order before 15:30 CET on Monday 2026-08-10
Up to 1,079 FT ready to ship on Thursday 2026-08-13
Order before 15:30 CET on Monday 2026-08-10
Up to 1,167 FT ready to ship on Monday 2026-08-17
Order before 15:30 CET on Monday 2026-08-10
270 FT available on request, fees apply
Special order from vendor stock.

CAN24TST120 is a 24 AWG, 120 Ω CAN bus cable for avionics data-bus wiring. Supplied by the foot, it is intended for installations that specify this cable part number.

  • Manufacturer part number: CAN24TST120
  • 24 AWG cable with 120 Ω impedance
  • Velocity of propagation: 79%
  • Outside diameter: approximately 3.6 mm
  • Minimum bend radius: approximately 36 mm
  • Operating temperature: -55 °C to +150 °C
  • Type: Maxflite CAN Bus cable

Garmin installation documentation identifies CAN24TST120(CIT) as a CAN bus cable option. Refer to the applicable current equipment installation manual and approved aircraft data before installation.

Overview

GARMIN recommends the use of P/N CAN24TST120(CIT) cable to interface the CAN Bus on G3X, G5, GMU11, GAD29B, GFC500, GMC507, GSA28, etc.

Note: Please refer to GARMIN’s STC Installation Manual for specific details.

Specifications

  • Details: Carlisle CAN24TST120
  • AWG: 24
  • Impedance: 120 (Ohms)
  • Velocity of Propagation: 79%
  • Cable Diameter (in): 0.142
  • Cable Weight (lbs): 14
  • Min. Bend Radius (in): 1.42
  • Operating Temperature: -55 to 150°C
  • Type: Maxflite - CAN Bus
  • Meets FAR 25.853 and Boeing/Airbus Smoke and Toxicity



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.