Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

MGL Stratomaster Vega 2-1/4 Fuel Computer

https://www.roctexo.com/web/image/product.template/3585/image_1920?unique=9795eef
Part numbers : RX1-11-15991 , FF-4 , VEGA-FF-4 , 11-15991
Unit of Measure: EA

366.30 EUR / EA 366.3 EUR 366.30 € excl. VAT

366.30 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 2 EA ready to ship on Thursday 2026-10-15
Order before 16:00 CET on Tuesday 2026-10-13
2 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The MGL Stratomaster Vega FF-4 is a compact 57 mm (2¼ in) colour-display fuel computer designed to monitor fuel-related information in single- or dual-tank installations.

Depending on the installed senders and configuration, the FF-4 can work with fuel-flow and fuel-level inputs, as well as a single fuel-pressure sender. Where only fuel-flow input is used, fuel level can be calculated from fuel consumption. Differential fuel-flow calculations are supported for fuel-return systems, and fuel-injector systems can also be accommodated.

  • 57 mm (2¼ in) sunlight-readable colour display
  • Supports single- or dual-tank fuel monitoring
  • Interfaces with one or two fuel-flow senders and fuel-level senders
  • Multi-point fuel-level calibration for non-linear or irregularly shaped tanks
  • Configurable fuel-flow sender K-factor for calibration
  • RS-232 NMEA GPS input for ground-speed-based fuel-range calculations
  • CAN-bus interface for connection to an external MGL RDAC remote data-acquisition unit
  • External alarm output

Manufacturer part numbers: FF-4, VEGA-FF-4.

Refer to the MGL Avionics Vega FF-4 operating manual for installation requirements, wiring, supported sender types and configuration guidance.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.