Skip to Content
  1. All Products
  2. All Products
  3. Bogert Cable Piper PA38-112
Select currency EUR
Bogert Cable Piper PA38-112

Image for illustration only. It may show a product series rather than the exact product offered.

Bogert Cable Piper PA38-112

https://www.roctexo.com/web/image/product.template/49511/image_1920?unique=340351a
Part numbers : RX1-11-15192 , 03M-KIT-PA-38-112 , 11-15192
Unit of Measure: EA

390.55 EUR / EA 390.55 EUR 390.55 € excl. VAT

390.55 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

The Bogert Aviation Low-Loss copper cable kit, manufacturer part number 03M-KIT-PA-38-112, is configured for Piper PA-38-112 Tomahawk aircraft in the manufacturer-listed serial-number range 38-78A0001 through 38-82A0122.

The kit uses flexible 1-gauge M22759 copper cable with slim-head terminals and heat-shrink insulation. Bogert Aviation supplies the cable assemblies cut to length and preassembled to support a straightforward replacement of the applicable battery and starter cable installation.

  • Manufacturer: Bogert Aviation
  • Manufacturer part number: 03M-KIT-PA-38-112
  • Flexible 1-gauge M22759 copper cable
  • Slim-head terminals with heat-shrink insulation
  • Manufacturer-stated documentation includes instructions, cable schematic, sample logbook entry and STC/AML paperwork
  • FAA/PMA approval stated by the manufacturer under STC SA3531NM

Bogert Aviation states that its copper cable kits are intended to reduce voltage drop between the battery and starter and improve starting-system performance. The manufacturer also states that the kit exceeds Piper Service Bulletins SB836 and SB836A.

Please verify aircraft serial number, installed configuration and applicable EASA approval or acceptance requirements before installation.

Contact Us

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.