Skip to Content

Artex ELT 345 406 USA With Whip Antenna

Hazardous product
Hazardous material Special shipping rules and carrier restrictions may apply.
https://www.roctexo.com/web/image/product.template/36744/image_1920?unique=99a391e
Part numbers : RX1-11-13989 , 8102 , 11-13989
Unit of Measure: EA

3500.70 EUR / EA 3500.7 EUR 3,500.70 € excl. VAT

3500.70 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
145 EA available on request, fees apply
Hazardous material special order from vendor stock.

The ARTEX ELT 345 Standard Kit, manufacturer part number 8102, is an emergency locator transmitter package configured with a black whip antenna and standard 2-wire remote switch. The kit is identified by ARTEX as a USA-programmed configuration.

The ELT 345 transmits on 406.040 MHz and 121.5 MHz and incorporates a GPS navigational interface accepting NMEA 0183 or RS-232 data. GPS position data can be included in the emergency transmission. Activation is available manually through the ELT or cockpit remote switch, or automatically through the integral G-switch.

  • Manufacturer: ARTEX
  • Manufacturer part number: 8102
  • Model: ELT 345
  • 406.040 MHz and 121.5 MHz emergency transmission frequencies
  • Built-in GPS navigational interface: NMEA 0183 or RS-232
  • Standard black whip antenna, approximately 59 cm tall
  • Standard 2-wire remote switch
  • General aviation installation kit and coaxial cable included in the manufacturer kit configuration
  • BNC female output connector

For installation, operation, continued airworthiness and registration requirements, consult the applicable aircraft data and the manufacturer documentation. Approval and suitability for a specific aircraft or operating jurisdiction must be confirmed by the installer or operator.

Manufacturer installation, operation and maintenance manual (PDF)

Roctexo part number: RX1-11-13989.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.