Skip to Content
  1. All Products
  2. All Products
  3. RAMI AV-200 Whip Antenna TSO
Select currency EUR
RAMI AV-200 Whip Antenna TSO

Image for illustration only. It may show a product series rather than the exact product offered.

RAMI AV-200 Whip Antenna TSO

https://www.roctexo.com/web/image/product.template/44074/image_1920?unique=7b864c5
Part numbers : RX1-11-12892 , AV-200 , ASS-11-12892 , 11-12892
Unit of Measure: EA

146.26 EUR / EA 146.26 EUR 146.26 € excl. VAT

146.26 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 3 EA ready to ship on Monday 2026-09-28
Order before 17:00 CET Tomorrow
26 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The RAMI AV-200 is a passive, two-frequency wire whip antenna for airborne emergency locator transmitter (ELT) installations. Designed for General Aviation aircraft operating at speeds up to 250 knots, it provides coverage at 121.5 MHz and 406 MHz.

Manufacturer part number: AV-200.

  • Application: airborne ELT antenna
  • Frequency: 121.5 MHz and 406 MHz
  • FAA TSO: C126a
  • Impedance: 50 ohms nominal
  • Polarisation: vertical; radiation pattern: omnidirectional
  • Connector: BNC female
  • Maximum VSWR: 2.0:1 at 121.5 MHz; 1.5:1 at 406 MHz
  • RF power capacity: 10 W continuous wave
  • Maximum height: approximately 610 mm
  • Designed for aircraft speeds up to 250 knots

RAMI states that the AV-200 meets DO-160G Section 8, Category U vibration requirements and is qualified for helicopter installation where related rotor frequencies are unknown. Installation must be assessed and approved as applicable for the specific aircraft and airworthiness requirements.

Relevant manufacturer documentation includes AV-200 installation instructions, FAA TSO authorisation and a General Aviation environmental qualification form.

Contact Us

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.