Skip to Content
  1. All Products
  2. All Products
  3. ACS Ignition Service Kit A-3650-2
Select currency EUR

ACS Ignition Service Kit A-3650-2

https://www.roctexo.com/web/image/product.template/85300/image_1920?unique=b79f530
Part numbers : RX1-11-03654 , A-3650-2 , 11-03654
Unit of Measure: EA

32.02 EUR / EA 32.02 EUR 32.02 € excl. VAT

32.02 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
2 EA ready to ship Today
Order before 15:30 CET Today
8 EA available on request, fees apply
Special order from vendor stock.

The ACS Ignition Service Kit A-3650-2 is a service-parts kit for ACS ignition switches. It provides replacement internal switch contacts, lubricant, a diode assembly and a terminal board for ignition-switch maintenance.

The supplied diode assembly is specified for starter solenoids with one or two coil contacts. The kit is referenced for work in accordance with ACS Ignition Switch Service Bulletin SB92-01.

  • Manufacturer part number: A-3650-2
  • Product type: ignition switch service kit
  • Includes replacement internal contacts, lubricant, diode assembly and terminal board
  • Diode assembly for starter solenoids with one or two coil contacts
  • Unit of measure: each

Please confirm suitability for the specific installed ignition switch and carry out maintenance in accordance with the applicable technical data and maintenance requirements.

Contact Us

Terms and Conditions

Share

Overview

Consists of replacement internal switch contacts, lubricant, diode assembly, and terminal board as required for compliance with ACS Ignition Switch Service Bulletin SB92-01. Kit A-3650-2 contains diode assembly for starter solenoids with one or two coil contacts.

JUMPER USED WHEN LEFT MAG HAS IMPULSE

COUPLING OR IS RETARD BREAKER MAG

Installation of Ignition Switch

A) Use SHIELDED wire on all connections and ground to nearest structural member.  

B)  Terminal 1 must have a jumper installed when LEFT MAG has IMPULSE COUPLING or is RETARD BREAKER MAG.

C)  Connect wire from RIGHT MAG to terminal 1 of drawing.

Connect wire from LEFT MAG to terminal 2 of drawing.

Connect wire from STARTER SOLENOID to terminal 3 of drawing.

Connect wire from Positive terminal of power supply to terminal 4 of drawing.

Connect wire from terminal 5 of drawing to nearest structural membe.  


Made in USA



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.