Skip to Content
  1. All Products
  2. All Products
  3. Zeftronics Volt Reg R15V00-A
Select currency EUR
Zeftronics Volt Reg R15V00-A

Image for illustration only. It may show a product series rather than the exact product offered.

Zeftronics Volt Reg R15V00-A

https://www.roctexo.com/web/image/product.template/79202/image_1920?unique=bf85757
Part numbers : RX1-07-00628 , R15V00-A , ASS-07-00628 , 07-00628
Unit of Measure: EA

502.83 EUR / EA 502.83 EUR 502.83 € excl. VAT

502.83 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 7 EA ready to ship on Thursday 2026-10-08
Order before 16:00 CET on Tuesday 2026-10-06
4 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The Zeftronics R15V00-A, also identified by Zeftronics as the R15V00 Rev A, is a 14 V alternator controller unit combining voltage regulation with an integrated over-voltage sensor.

Designed to control alternator field current through remote voltage sensing, the unit helps maintain system voltage while providing protective and diagnostic functions for the charging system.

  • Voltage regulation: 14.2 V ± 0.2 V
  • Maximum field current: 5 A
  • Over-voltage protection threshold: 16.0 V ± 0.4 V
  • Integrated over-voltage sensing and protection
  • Remote voltage sensing
  • Low-voltage/over-voltage warning-light output
  • Field-to-ground fault protection
  • On-unit troubleshooting light (TSL)

Manufacturer reference replacement part numbers include Cessna C611001-0201, C611001-0101 and C611001-0102; Beech 33-380010; Electrodelta VR600 and VR600A; PFT DGR 6; and Ford D4FF-10316-BA/CA. Verify the applicable aircraft configuration, installation instructions and approved data before installation.

Manufacturer part number: R15V00-A.

Contact Us

Terms and Conditions

Share

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.