Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

Tanis STC Engine Preheat Kit 6 Cylinder Continental & Lycoming 115V

https://www.roctexo.com/web/image/product.template/124229/image_1920?unique=b0bf6d8
Part numbers : RX1-05-14829-1 , TSP6CYL-2927-115 , 05-14829-1
Unit of Measure: EA

1309.12 EUR / EA 1309.12 EUR 1,309.12 € excl. VAT

1309.12 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Up to 4 EA ready to ship on Monday 2026-10-05
Order before 17:00 CET on Friday 2026-10-02
Up to 12 EA ready to ship on Thursday 2026-10-08
Order before 17:00 CET on Friday 2026-10-02
20 EA available on request, inbound freight fee of 60 EUR applies
Special order from vendor stock.

The Tanis TSP6CYL-2927-115 is a 115 V engine preheat kit for eligible six-cylinder Continental and Lycoming piston-engine installations. It uses a multipoint heating arrangement intended to warm the engine and attached accessories before operation in cold conditions.

  • Manufacturer part number: TSP6CYL-2927-115
  • For eligible six-cylinder Continental and Lycoming engine installations
  • Threaded heat elements for the cylinder assemblies, fitted in an intake-bolt or rocker-cover-screw location as applicable
  • Two pad heat elements for the crankcase, oil sump, or oil tank as applicable
  • Dedicated wiring assembly with LED system power indication and circuit overload protection
  • Self-regulating system design
  • Stated installed electrical load: 460 W, 4.0 A at 115 V

Installation suitability must be verified against the applicable Tanis installation instructions and approved model list for the specific engine and aircraft. This kit is described as an STC/PMA kit in the supplied product source; no EASA approval claim is made.

Relevant documentation: Tanis installation instructions TNP2927, as referenced in the associated approved model list.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.