Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

McFarlane Control Dual 8Foot Round Red Knob MCC101D096-RR

https://www.roctexo.com/web/image/product.template/98661/image_1920?unique=a73d2bf
Part numbers : RX1-05-11238 , MCC101D096-RR , 05-11238
Unit of Measure: EA

235.94 EUR / EA 235.94 EUR 235.94 € excl. VAT

235.94 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

McFarlane Aviation MCC101D096-RR is a dual, non-locking choke control with an approximately 2.4 m conduit and a round red anodised-aluminium knob. It is designed by the manufacturer for dual-carburettor Rotax 912/914-series engine choke installations, providing a tidy alternative to a separate splitter box.

The all-metal control uses a high-temperature Teflon-lined conduit for smooth operation. An internal elastomer seal provides vibration damping and light operating resistance; where the choke installation incorporates a return spring, the control returns to the closed position when released.

  • Manufacturer part number: MCC101D096-RR
  • Dual, non-locking configuration
  • Approx. 2.4 m conduit length, measured from the panel fitting to the end of the conduit
  • Round red anodised-aluminium knob
  • Minimum travel: 89 mm
  • Conduit outside diameter: approx. 4.8 mm
  • 1.6 mm, 7 x 7 stainless-steel inner wire
  • Approximate maximum pull load: 110 N; not designed for push loads
  • Operating temperature: approximately -54 °C to +232 °C
  • 7/16-20 UNF panel mounting thread
  • Includes two adjustable barrel stops for attachment to the carburettor choke arms

The conduit may be trimmed to suit the installation; the inner wires extend at least 76 mm beyond the conduit. This control is not EASA/FAA approved and must not be used for flight controls or flight-control trim tabs.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.