Skip to Content

Image for illustration only. It may show a product series rather than the exact product offered.

McFarlane Control Choke Dual 8Foot Round Blue Knob MCC101D096-RLC

https://www.roctexo.com/web/image/product.template/38698/image_1920?unique=a73d2bf
Part numbers : RX1-05-11237 , MCC101D096-RLC , 05-11237
Unit of Measure: EA

228.46 EUR / EA 228.46 EUR 228.46 € excl. VAT

228.46 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
Not in stock
Available to order. Lead times vary.

McFarlane MCC101D096-RLC is a dual, non-locking choke control with a round blue anodised-aluminium knob and a 2.4 m (8 ft) conduit. It is designed for dual-carburettor choke installations, including Rotax 912/914 series engine applications.

The control uses all-metal construction with a high-temperature Teflon-lined conduit to support smooth, consistent operation. An internal elastomer seal provides vibration damping and light operating resistance. Where the choke installation uses a return spring, the control returns to the closed position when released.

  • Manufacturer part number: MCC101D096-RLC
  • Dual choke control; non-locking configuration
  • Round blue knob
  • Conduit length: 2.4 m (8 ft), measured from panel fitting to conduit end
  • Minimum travel: 89 mm (3.5 in)
  • Conduit outside diameter: 4.8 mm
  • 1/16 in, 7x7 stainless-steel inner wire
  • Includes two adjustable barrel stops for attachment to carburettor choke arms
  • Adjustable cable stops allow travel limitation; cable may be trimmed to suit installation requirements
  • Approximate maximum pull load: 11 kg; not designed for push loads
  • Operating temperature range: approximately -54 °C to +232 °C

Not EASA/FAA approved. Not intended for use on certified aircraft, flight controls, or flight-control trim tabs. Installation and suitability should be confirmed against the applicable engine, aircraft, and maintenance documentation.

These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.