Skip to Content
  1. All Products
  2. All Products
  3. 3/16 Nylaflow Tubing Type H
Select currency EUR
3/16 Nylaflow Tubing Type H

3/16 Nylaflow Tubing Type H

https://www.roctexo.com/web/image/product.template/29183/image_1920?unique=ccec4a8
Part numbers : RX1-05-04355 , 05-04355
Unit of Measure: FT

0.77 EUR / FT 0.77 EUR 0.77 € excl. VAT

0.77 EUR / FT excl. VAT

Not Available For Sale

This combination does not exist.

Availability
50 FT ready to ship Tomorrow
Order before 15:30 CET Tomorrow
Up to 415 FT ready to ship on Thursday 2026-08-20
Order before 15:30 CET Tomorrow
Up to 687 FT ready to ship on Monday 2026-08-24
Order before 15:30 CET Tomorrow
278 FT available on request, fees apply
Special order from vendor stock.

Type H Nylaflow nylon tubing with a 3/16 in (4.8 mm) outside diameter and an approximately 0.111 in (2.8 mm) inside diameter. Supplied by the foot.

This flexible nylon pressure tubing has a smooth internal bore and is described as abrasion-resistant. It may be used for oil, air, vacuum, fuel and low-pressure hydraulic-line duties, as well as for protective conduit or short bushing and washer applications, subject to confirmation against the applicable installation and maintenance data.

  • Roctexo part number: RX1-05-04355
  • Type: H / high-burst-pressure Nylaflow tubing
  • Outside diameter: 3/16 in (4.8 mm)
  • Inside diameter: approximately 0.111 in (2.8 mm)
  • Material: nylon
  • Unit of supply: foot
  • Connection note: Type H tubing requires SAE fittings; Poly-Flo fittings are not suitable for this tubing type.

Confirm tubing suitability, system pressure requirements, fitting selection and any required airworthiness approval before installation.

Contact Us

Terms and Conditions

Share

TypeODIDPSIPart Number
High
Bursting
Pressure		3/16.111
(appx.)		250005-04355

Overview

Nylon Polypenco. pressure tubing is a super tough, low friction, high flexibility tubing that can be used for cable protectors or in short pieces, as small bushings and washers.

Suitable for use in oil, air, vacuum, fuel and low pressure hydraulic lines. It resists abrasion and wears better than aluminum or steel tubing. Has an extremely smooth inner surface with a very low coefficient of friction. Used for brake lines, and also as a conduit for the rudder cables in the Rutan VariEze and Long-EZ. Rated 1000 psi. Sold by the foot.

Use Poly-Flo fittings with standard wall tubing.


Note: Poly Flo fittings cannot be used with High Burst Pressure tubing.

Must use SAE fittings 


Specifications

  • Suggested Temp Range: -65°F to +150°F



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.