Skip to Content
  1. All Products
  2. All Products
  3. G-8 Washer
Select currency EUR
G-8 Washer

Image for illustration only. It may show a product series rather than the exact product offered.

G-8 Washer

https://www.roctexo.com/web/image/product.template/103585/image_1920?unique=adf7a01
Part numbers : RX1-04-01989 , 04-01989
Unit of Measure: EA

0.33 EUR / EA 0.33 EUR 0.33 € excl. VAT

0.33 EUR / EA excl. VAT

Not Available For Sale

This combination does not exist.

Availability
90 EA ready to ship Tomorrow
Order before 15:30 CET Tomorrow
Up to 271 EA ready to ship on Monday 2026-09-28
Order before 15:30 CET Tomorrow
Up to 668 EA ready to ship on Thursday 2026-10-01
Order before 15:30 CET Tomorrow
1,580 EA available on request, fees apply
Special order from vendor stock.

The G-8 Washer is a stainless-steel washer designed for No. 8 fasteners, with the outside diameter of a No. 10 washer. Its approximately 19 mm outside diameter provides a broader bearing surface where enlarged holes in fairings or similar panels require additional coverage.

Made from 304 half-hard stainless steel and machine tumbled for a bright finish, the G-8 washer is intended to help achieve effective clamp-up between the fastener and the panel without the washer bottoming on the fastener cone.

  • For No. 8 fasteners
  • Approx. 19 mm outside diameter
  • 304 half-hard stainless-steel construction
  • Machine-tumbled bright finish
  • Unit of measure: each
Contact Us

Terms and Conditions

Share

Overview

A No. 8 washer with the same O.D. as a No. 10 (0.75). Great for those oversize holes in fairings. Unlike the No. 10 washer with a No. 8 screw, these washers will tighten down on the fairing (not bottom out on the cone) thus providing the proper "clamp up" between the fastener and the fairing.

The G-8 washers are Made in the USA from 304 (1/2 hard) Stainless Steel and are machine tumbled for a shiny finish.



These products might also be of interest

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.