RX1-05-11240

MCC101D144 is a dual, non-locking control assembly with an approximately 3.7 m (12 ft) conduit length, supplied without a knob. It is designed to provide two cable outputs from a single panel-mounted control for a neat installation without a separate splitter box.

The control has an all-metal construction and a high-temperature Teflon-lined conduit intended to support smooth, consistent operation in engine-compartment environments. An internal elastomer seal provides vibration damping and light operating resistance; the control does not incorporate a locking mechanism.

• Manufacturer part number: MCC101D144
• Dual control configuration
• Conduit length: approximately 3.7 m (12 ft)
• Supplied without knob; accepts a 10-32 threaded knob
• Minimum travel: 89 mm (3.5 in)
• Conduit outside diameter: approximately 4.8 mm (0.188 in)
• 1/16 in, 7x7 stainless-steel inner wire
• Includes two adjustable barrel stops for cable-end attachment
• Adjustable cable stops allow travel limitation and trimming to installation requirements

Important: This control is not EASA/FAA approved and is not intended for certified aircraft, flight-control, or flight-control trim-tab use. It is specified for pull loads only and is not designed for push loads.