RX1-05-11242

McFarlane Aviation MCC101D144-RBC is a non-locking dual choke control with a 3.66 m (12 ft) conduit and a round black knob engraved “CHOKE”. It is designed by the manufacturer for dual-carburettor Rotax 912/914 series engine choke installations, providing a clean dual-control routing without a splitter box.

The all-metal control uses a high-temperature PTFE-lined conduit for smooth operation. An internal elastomer seal provides vibration damping and light operating resistance; where the installation incorporates a return spring, the control returns to the closed position when released.

• Manufacturer part number: MCC101D144-RBC
• Configuration: dual, non-locking choke control
• Control length: 3.66 m (12 ft), measured from panel fitting to conduit end
• Knob: round black anodised aluminium, engraved “CHOKE”
• Minimum travel: 89 mm
• Conduit outside diameter: approximately 4.8 mm
• Inner wire: approximately 1.6 mm, 7×7 stainless steel
• Maximum pull load: approximately 111 N; not designed for push loads
• Operating temperature: approximately −54 °C to +232 °C
• Includes two adjustable barrel stops for attachment to carburettor choke arms
• Panel mounting thread: 7/16-20 UNF

The conduit may be trimmed to suit the installation; the wires extend at least 76 mm beyond the conduit. This control is not EASA/FAA approved for use on certified aircraft and must not be used for flight controls or flight-control trim tabs. Installation and suitability should be verified by appropriately qualified personnel.

Manufacturer documentation: McFarlane Aviation product information for MCC101D144-RBC.