ROCTEXOAEROSPACE
A commercial account is required before proceeding to checkout. Select a commercial account or create a commercial account.
You are using our new webshop. The old webshop is still available.
RX1-08-01187

Image for illustration only. It may show a product series rather than the exact product offered.

RX1-08-01187

Homebuilders Valve Cover Gasket For Lyc

6.68 EUR/EA

Excluding VAT

Availability

4 EA ready to ship TodayOrder before 15:30 CET Today
AOG

AOG service might be available even outside our opening hours. AOG services incur a fee starting from 100 EUR.

Accept and see AOG contact details

+46106500380 aog@roctexo.com

Up to 36 EA ready to ship on Thursday 2026-11-12Order before 15:30 CET Today
Up to 85 EA ready to ship on Monday 2026-11-16Order before 15:30 CET Today
165 EA available on request, inbound freight fee of 60 EUR appliesSpecial order from vendor stock.

Part numbers

Roctexo
RX1-08-01187
Manufacturer
1000-0170
Vendor
ASS-08-01187
Vendor
08-01187

Product details

Overview

Note: 08-05882 is similar to 67193 and RG-67193 but not FAA Approved for Certified Aircraft. 08-01187 is similar to 75906 and RG-75906 but not FAA Approved for Certified Aircraft.

"O" Series Lycoming Valve Cover Gaskets

These homebuilder's Lycoming valve cover gaskets replace the original cork gaskets which come standard on Lycoming 0-235, 0-320 and 0-360 engines. These new gaskets are molded from high temperature silicone rubber and do not harden over time so they can be re-used again and again. This hi-tech silicone rubber offers a much lower compression set, so it is superior at maintaining an oil-tight seal for the life of the engine. NOT FAA approved. For experimental aircraft only.

Angled Valve "IO" Series Lycoming Valve Cover Gaskets These gaskets are for the fuel injected "IO" series, sometimes referred to as the Angle Valve cylinder Lycoming, as well. these gaskets are molded from the same high-temperature silicone rubber as the "O" series gaskets above, and do not harden over time, so they can be reused again and again. This hi-tech silicone rubber offers a much lower compression set, so it is superior at maintaining an oil-tight seal for the life of the engine. They are not FAA approved and are not manufactured under a PMA. These are similar to Lycoming part number 67193 used on Angled valve Lycoming engines IO-360, IO-540, IO-720.