ROCTEXOAEROSPACE
A commercial account is required before proceeding to checkout. Select a commercial account or create a commercial account.
You are using our new webshop. The old webshop is still available.
RX1-61-275

Image for illustration only. It may show a product series rather than the exact product offered.

RX1-61-275

Firewall Shields 61-275

11.70 EUR/PAIR

Excluding VAT

Availability

2 PAIR ready to ship TodayOrder before 15:30 CET Today
AOG

AOG service might be available even outside our opening hours. AOG services incur a fee starting from 100 EUR.

Accept and see AOG contact details

+46106500380 aog@roctexo.com

Up to 12 PAIR ready to ship on Thursday 2026-11-12Order before 15:30 CET Today
Up to 13 PAIR ready to ship on Monday 2026-11-16Order before 15:30 CET Today
13 PAIR available on request, inbound freight fee of 60 EUR appliesSpecial order from vendor stock.

Part numbers

Roctexo
RX1-61-275
Manufacturer / Vendor
61-275
Vendor
ASS-61-275

Product details

Overview

Two piece firewall shield, 3/8-Inch hole and various dimple sizes for grommets.

Two piece shields for use over cables or wires with large end-fittings or existing installations. Single piece for use where the cable or wire may pass through the hole. Flat shields designed for use on wooden or composite firewalls using a fire resistant sealant to prevent leaks. Both types of shield available in flat or with dimple to accommodate rubber grommets up to outside diameter. Actual hole size in 2 piece shields is slightly larger than indicated to prevent chafing cable. Ream pilot hole in single piece shields oversize for the size grommet used. Use grommets that fit tightly around the cable or wire to insure a good seal. Shields may be installed with screws, bolts and plate nuts or rivet nuts. Install cable and grommet in firewall. Locate the shield to insure that it is centered on the cable - then drill attach holes in firewall. Shields predrilled with 5/32” mounting holes. If more than one cable passes through grommet fire resistant sealant must be applied to grommet.

**Caution: Any holes drilled in the firewall are potential source of carbon monoxide in the cockpit. Extreme caution must be exercised when installing firewall shields in your aircraft. They do not provide the nec essary seal around cables or wires to prevent carbon monoxide, smoke or fire from entering the cockpit. The shields are designed only to protect the sealing material (grommets/gaskets) from excessive heat.